menu
Cerrar

What is Classic Mettal?

Classic Mettal is the range of ready-to-use metal coatings with the possibility of a rust finish.

It is a decorative finish that offers a wide variety of application possibilities on walkable and non- walkable surfaces. It stands out for its ability to turn any room and design into completely new surfaces with authentic rust finishes.

Classic Mettal contains real metal particles of copper, bronze, iron and brass, depending on the result you want to obtain. Its application offers two possibilities: metallic look finishes and rust finishes, thanks to the application of Mettal Activator. It can be applied on any surface and indoors and outdoors.

Logo Pure Mettal

The ready to use metal pigments in the Classic Mettal range can also be given the appearance of rust, if Mettal Activator is applied

Copper + Mettal Activator


Bronze + Mettal Activator


Iron 004 + Mettal Activator


Iron 030 + Mettal Activator


Types of Classic Mettal

Classic Mettal
Classic Mettal Copper
Classic Mettal
Classic Mettal Bronze
Classic Mettal
Classic Mettal Oxide Iron 004
Classic Mettal
Classic Mettal Oxide Brass
Classic Mettal
Classic Mettal Oxide Iron 030

Technical characteristics

Icon
It can be applied on any type of surface

microcement, concrete, brick, ceramic, etc.

Icon
High adherence to the substrate

In not very absorbent areas we recommend Primacem Plus.

Icon
Product ready to use

Do not dilute with water.

Icon
Versatility of application

Can be applied with a trowel, brush, sponge, roller or spray gun.

Consumption

The performance will depend on the substrate to be coated and the method of application. In a trowel application, the coverage is the following: 0,15 L/m².

Packaging

Classic Mettal is available in 1L containers.

+ STEP BY STEP
Step 1. Cleaning and preparation of the substrate.
We must ensure that the surface is well consolidated, dry and, if necessary, bonded. Vacuum it to leave it clean.
icon
Step 2. Primer.
Apply a coat of primer Primacem ABS/PLUS.
icon
Step 3. Decoration.
Apply the desired Classic Mettal product with a trowel on the surface. Allow to dry for 24 hours.
icon
Step 4.Sanding / oxidising.
Sanding and finally polishing. Clean the surface to remove dust. For a rusty finish use Mettal Activator.
icon
Step 5. Sealing.
Seal with two coats of Presealer to prevent oxidation.
icon
Step 6. Protection.
Apply two coats of Topsealer WT A+B to protect the surface
icon
microcementos
microcementos